1) Gather Your Equipment: Equipment Needed: Total station, tripod, tribrach, controller, cables, survey stake or nail, and a mallet. Tip: Ensure all equipment is charged and ready for use. 2) Establish and Mark a Point of Reference: Identify a fixed point to serve as your survey's point of reference. Mark it: Secure this point with a stake or nail for visibility. 3) Set Up the Tripod at the Reference Point: Open the tripod and position it directly over the reference point. Alignment Tip: Center the tripod approximately over the marked stake. 4) Attach the Tribrach and Coarse Level: Connect the tribrach and secure it on the tripod. Initial Leveling: Use the coarse level on the tripod for preliminary adjustments. 5) Adjust as Necessary: Fine-tune the tripod to get it as close as possible to being level. Check Alignment: Ensure it is centered over the reference point. 6) Place the Total Station on the Tripod: Carefully attach the total station to the tripod without disturbing its position. Balance Tip: Ensure it remains aligned with the reference point. 7) Connect Cables: Attach the battery pack and connect the controller to the total station. Ensure Proper Connection: Check that cables are securely connected. 8) Power On and Start Controller: Turn on the total station and activate the fine-level function on the controller. Device Check: Confirm that all components are responding correctly. 9) Make Fine Adjustments: Use the fine-level feature to center the total station precisely over the reference point. Final Check: Ensure the instrument is perfectly level. 10) You’re Ready to Survey: Begin taking measurements as required for your project, using the total station’s advanced surveying features. Source: https://www.engineersupply.com/How-to-use-a-total-station.aspx Thanks for sharing Ziad Samir